Learn how to configure VLAN and NIC Teaming on Windows, VMware, and Linux, with clear examples, aggregation modes, and network best practices.

It is not a best practice to have two NIC on the same host, on the same subnet - unless you are doing some type of bonding of interfaces (supported by the host and the switch).

Looking for the best 10GbE network switches for VLANs? Our team tested 10 top models in 2026. Compare SFP+, 10Gbase-T, fanless, and Layer 3 picks.

For example, you might shape (or police) at gig rate on a 10g interface, or 800 Mbps on a gig interface. In other words, if you want to limit your bandwidth to gig, you've already doing that on a gig interface.

Even though fiber optic cables are cheaper, purchasing several SFP modules along with the fiber cables can be more expensive than DAC cables. The SFP ports on the TP-Link switches are not vendor locked so most any SFP modules and DAC cables should work.

You are allowing both NIC's to be used based on physical NIC load which will utilise your total bandwidth potential. Network IO will protect you from contention and allow the right traffic through.

Would it be better to configure as 2 stacks, a Master and Backup in each cabinet, then connect the switches with the remaining 10GB ports configured as network or uplink ports instead of stacking ports?

Traffic shaping allows you to control the traffic going out an interface in order to match its flow to the speed of the remote target interface and to ensure that the traffic conforms to policies contracted for it.

Traffic shaping allows you to control the traffic going out an interface in order to match its flow to the speed of the remote target interface and to ensure that the traffic conforms to policies contracted for it.

In this discussion, lets explore the best ways to set up Inter-VLAN Routing on Cisco devices, using simple explanations and clear examples to help configure network efficiently.